Explore UAB

UAB News Stay informed with the latest updates
Campus & Community 2025-06-30

In United States Publish
Post Time: 2025-06-30

Learn how to replace the #dryer belt on a common Kenmore dryer. This #diy procedure will also work when replacing the belt on common Whirlpool, Amana, Maytag and Roper dryers. Once you #replace the belt, reassemble the dryer by reversing the steps shown to access the belt. To order a replacement dryer belt, visit: For dryer repair, schedule service at: Unplug the dryer before beginning the repair. Warning: Undertaking repairs to appliances can be hazardous. Use the proper tools and safety equipment noted in the guide and follow all instructions. Do not proceed until you are confident that you understand all of the steps and are capable of completing the repair. Some repairs should only be performed by a qualified technician. Unplug the dryer. If it's a gas dryer, shut off the gas. Wear work gloves to protect your hands. Pull the lint screen out of the housing in the top panel of the dryer. Use a Phillips screwdriver to remove the 2 screws that secure the lint screen housing to the top panel. To release the clips that lock the top of the dryer in place, push a putty knife under the lid near the left and right edges of the front of the dryer. Lift the top and prop it securely against the wall behind the dryer. Use a slot screwdriver to release the locking tab on the wire harness plug for the door switch. Disconnect the wire harness. Use a 5/16-inch nut driver to remove the front panel mounting screws from the inside of the dryer. Pull the front panel forward slightly, and then lift and unhook it from the 2 bottom hangers. Pull the front panel off of the dryer and set it aside. Pull the broken belt out of the dryer. Position the new drive belt on the dryer drum. Lift the front of the drum to access the drive motor and idler pulley. Thread the drive belt through the idler pulley. Push the idler pulley to the right and loop the drive belt over the motor pulley. Position the front panel on the hangers at the bottom of the dryer. Line up the mounting holes and reinstall the screws in the top of the front panel to secure it to the dryer. Plug the wire harness back into the plug on the door switch. Make sure the locking tab engages properly. Lower the top panel and snap it into place. Reinstall the screws in the lint duct housing and reinstall the lint screen. Plug the dryer into the wall outlet. If it's a gas dryer, turn on the gas supply to the dryer.


How To Replace A Dryer Belt For Country: United States. City: Buffalo, Elk Grove, Gresham, Kansas City, Rochester

Tag: #Click Through The Up Coming Page, #internet site, #just click the up coming article, #read the article, #Read Much more

How to Replace a Dryer Belt

Back to Top